AC-DC-OBC

3.3KW Vehicle On Board Charger-3.3KW Vehicle AC-DC Charge Module

Introduction

Introduction

Main specification:

Type	Input	Rated Pout	Rated Vout	Output range	3D
TR1001	90~265VAC	3.3KW	540VDC	0~720V/0~6A	TYPE A, TYPE B
TR1002	90~265VAC	3.3KW	360VDC	0~500V/0~10A	TYPE A, TYPE B
TR1003	90~265VAC	3.3KW	144VDC	0~190V/0~22A	TYPE A, TYPE B
TR1004	90~265VAC	3.3KW	108VDC	0~140V/0~30A	TYPE A, TYPE B
TR1005	90~265VAC	3.3KW	72VDC	0~95V/0~45A	TYPE C
TR1006	90~265VAC	3.3KW	48VDC	0~68V/0~60A	TYPE C
TR1007	90~265VAC	3.3KW	24VDC	0~36V/0~100A	TYPE A, TYPE B
TR1007	90~265VAC	3.3KW	24VDC	0~36V/0~100A	TYPE C

Overview:

Type		TYPE A	TYPE A	TYPE A
Describe		Basic	30W aux power	Work with dc station
Control board color		Back	Yellow	Red
S.N.		901.100*0000.00	901.100*0000.01	901.100*0000.02
	CAN bus	YES	YES	YES
	CAN bus isolate	NO	YES	NO
	485 com	YES	NO	NO
	TTL serial com	NO	NO	YES
	CC check and wake up	YES	YES	YES
	CC check and wake up	YES	YES	YES
	12V 0.3A fan driver	YES	YES	YES
	12V 3A aux power output	NO	YES	NO
	Dual color LED driver	YES	YES	YES
	CE Certification	NO	YES	NO
	Work with dc station	NO	NO	YES

Model Number
Vehicle Power Supply	Vehicle AC-DC charge module
Model Number	TR1001	TR1002	TR1003	TR1004
Type	A/B	A/B	A/B/C	A/B/C
Input Characteristic
Rated Input Voltage	220VAC
Input Voltage Range	90～265VAC
Rated input voltage frequency	50Hz
Input frequency range	45～65Hz
Starting Impulse Current	≤16A
Input power factor	≥0.99(@220Vin,Pomax)
Output Characteristic
Rated Output Power	3.3KW
Rated Output Voltage	540	360	144	108
Output Voltage Range	0～720	0～500	0~190	0~140
Output Current Range	0～6	0～10	0~22	0~30
Voltage regulation accuracy	±1%
Current regulation accuracy	±0.5A(Io≤10A)&≤±5%(Io>10A)
ripple coefficient of voltage	≤1%
Output Response Time	≤200mS
Typical Efficiency	≥94%	≥94%	≥94%	≥93%
Operating Noise	-
Protective Characteristic
Over and Under Voltage Protection	Input over and under voltage shutdown can be self-recovery, output over and under voltage shutdown can be self-recovery.
Output Reverse Connection and Short Circuit Protection	Output short circuit and reverse connection shutdown can be self-recovery
Over Heat Protection	When the heat sink temperature is higher than 75 ° C, it will reduce the output power. And it will disconnect the circuit when the temperature is higher than 95 ° C. It will restore the output when the charging temperature is lower than 85 ° C.
Environmental Condition
Operating Ambient Temperature	-40℃ ~ +85℃(internal temperature of integrated system cavity);
	Water cooling system liquid temperature ≤65℃
Storage temperature	-40～95℃
Cooling Function	Modular design, water cooling or air cooling housing/substrate is required
Communication Function	CAN network
Charging Function	Receive charging instructions to charge normally; No command charger is in standby state
Safety Characteristic
Dielectric strength	Primary side - secondary side 2000VAC				Original side - Housing 1500VAC
Insulation resistance	Primary side - secondary side ≥50MΩ
Harmonic current	Meet the requirements of GPSD
Vibration Resistance	After X,Y,Z three directions of sweep frequency vibration testing, no damage for parts , no loose for fastening piece
Resistance to Industrial solvents	Metal parts have a good corrosion protection layer
Salt Spray Resistance	Support
EMC characteristics
Electromagnetic immunity	Meet the requirements of EN61000-6-1
Electromagnetic disturbance	Meets the requirements of EN61000-6-3